Vici FTP User Manual

Valco Instruments Co. Inc. FTP Rev 11/13Fast Temperature Programmer Operator’s Manual Valco Instruments Co. Inc.800 · 367· 8424 sales 713 · 688· 934

6Verifying Column ParametersRemember that commands can be upper or lower case, and that they must always be followed by <enter>.To verify that

7Programming and Running a SequenceEntering Data for the StatesHeatingandcoolingsequencesarecontrolledbystates.State1istheidle-mode (sta

8Programming and Running a Sequence3. TypeSS2<enter>andtypethevaluesbelowforexamplestate2,followedby<enter>. :ss2 Active

9Programming and Running a SequenceLogging Column DataData logging allows the user to view column information collected by the FTC. Turn on data logg

10Starting the SequenceBeforethecolumnrampsequencewillstart,thecolumnmustbeturnedonandtheremustbea“ready”agviewableinthedatal

11Fan Installation and ModesInstallation1. Before turning on the fan, verify that the power to the column is off (Z-<enter>), to prevent column

12To View or Change the Fan ModeTo view the current fan mode setting:1. TypeFM<enter>. The response will be : fm  2(or 0, 1, or 3) 2indi

13Optional Electronic ControlExternalelectroniccontroloftheFTCisprovidedbya5volt,low-true,(1madrive)logiclevel interface. An externa

14WarrantyThisLimitedWarrantygivestheBuyerspeciclegalrights,andaBuyer mayalsohaveotherrightsthatvaryfromstatetostate.Foraper

This page intentionally left blank for printing purposes

Table of ContentsIntroduction ...

This page intentionally left blank for printing purposes

1IntroductionPlease read the manual completely before using the Fast Temperature Controller.The column controlled by the FTC will be heated very rapid

2Figure 2: Connecting the components to the rear panel (top) and front panel (bottom) of the Fast Temperature Controller. Components in gray boxes a

3Getting StartedCable ConnectionsRefer to Figures 1 and 2 as necessary.1. ConnecttheUSBcabletothefrontoftheFTCandtothecomputer.2. Conn

4Getting Started6. ClickApply, then OK.7. Onthenextscreen,selectFile > Properties > Settings, and click on ASCII Setup.8. IntheASCII

5Getting StartedViewing the Command SetTo view the list of commands for the FTC, type ??<enter>. All HyperTerminal commands must be followed by